With the development trend of new technologies, the quality and technology of pipe bending machines in my country have long been quite complete and stable with pipe production equipment such as hydraulic pipe bending equipment, automatic pipe bending equipment, laser pipe cutting machines and locks. Everyone is not easy to explore. Due to the emergence of new technology applications in the past, the stability level of mechanical equipment characteristics is relatively sensitive, but the current pipeline production line equipment is basically stable, so pay attention to maintenance after purchasing a machining center.

This way, when the tube is inserted into the journal, the iron pin comes out, and the iron pin that is not removed will fall into the car tank. As we all know, the pipe bender uses the oil pump to input the oil, and the hydraulic pressure is displayed according to the automobile relay. Therefore, after this iron pin enters the car fuel tank, most of the iron pins will be jumped out by the filter screen of the input oil pipeline, but very few iron pins will enter the oil pump, so that the iron pins sucked into the oil pump enter the automobile relay. However, this kind of iron pin cannot flow in the automobile relay, which causes the hydraulic relay to be blocked, and the oil cannot flow, resulting in the failure of the mutual cooperation state, and the bending equipment cannot work normally.

But what problems often occur in daily use of pipe benders? In the technical draft of the syslog, I think this issue has been mentioned long ago. Today, it is often said that the area where the hydraulic press is located is problematic because when the machine equipment is at the elbow, the fiber laser cuts the pipe, leaving a large number of small iron pins. If this iron pin cannot be cleaned, the bend in the bender will hit immediately. But many wear-resistant materials for pipe benders are bent with mandrels and are likely to wrinkle or collapse inside the pipe bender.