Prices of ordinary semi-automatic pneumatic pipe cutting machines and precautions during use.

Compared with the manual pipe cutting machine, the ordinary semi-automatic pneumatic pipe cutting machine has an advantage that the cutting speed is fast, which can achieve a very fast cutting speed. The price of semi-automatic pneumatic pipe cutting machine is not expensive, and you can buy it for several thousand and tens of thousands. Because it is easy to cut, it is very cost-effective. At present, there are two types of pneumatic semi-automatic pipe cutting machines: YJ-275Q and YJ-315Q. Using YJ-315Q semi-automatic pipe cutting machine, high-speed cutting can make the cutting efficiency higher, which can also bring greater profits to the enterprise. The price of the 315 semi-automatic pneumatic pipe cutting machine is not expensive, but it will be very labor-saving and time-saving during use. It can quickly meet the engineering requirements, and can cut many pipes at the same time, saving manpower. In the past, the pipe was clamped manually, and the pipe cutting machine head was manually pressed down for cutting, which was very labor-intensive and the work process was slow. The mastery of the cutting size is also not standard enough. It is necessary to measure the pipes one by one and then cut them. In the cutting process, the force is easy to cause errors in the cutting size, and the manpower will also be tired, so it is impossible to work for a long time without stopping. The 315 semi-automatic pneumatic pipe cutting machine only needs to set the size to be cut in advance, and then each feed will be cut according to the set backing positioning size, which does not require manual repeated measurement and inspection to achieve the purpose of saving time.

Because the semi-automatic pneumatic pipe cutting machine uses pneumatic clamping and pneumatic cutting, the cooling liquid is used to cool and lubricate the cutting saw blade during the cutting process, so debris such as iron filings will be generated during cutting. In order to prevent debris from blocking the dust removal device, or jamming the switch, etc. and causing malfunction. At the same time, the maintenance of the pipe cutting machine including the saw blade is also very important. The dirt on the surface should be completely removed. Generally, the saw blade made of W5 and W6 materials can cut about 1000 knives when cutting a 30*2.0 ordinary carbon steel pipe with a diameter of 30*2.0 knives. If there are burrs on the left and right or cut pipe sections, it must be repaired in time. In this way, the service life of the saw blade can be increased. If the semi-automatic pneumatic pipe cutting machine is stuck in any place or does not work properly, do not directly check the troubleshooting. But to cut off the power first, and then check to avoid accidents. The semi-automatic pneumatic pipe cutting machine is inexpensive, flexible in use, and small in size for easy transportation. Therefore, when a small project needs to use a pipe cutting machine, it can be done with a 275 or 315 semi-automatic pneumatic pipe cutting machine, which is very convenient, fast and efficient.