The use of the pipe bender is also a milestone improvement and improvement. This not only further improves the management ability, but also enhances the management of the entire social development. You also have a detailed understanding of the many uses of pipe bending equipment. Before application, we need to establish equipment installation and adjustment regulations to ensure the effectiveness of machine equipment application.

First of all, during the installation of the pipe bender, especially when installing the hydraulic seal, pay attention to whether the model specifications of the U-ring and O-ring installed inside the hydraulic cylinder are suitable. Specify the model and specifications, and use gasoline to clean the inside of the cylinder head during installation to avoid residual iron pins and burrs during drilling. If the burr inside the cylinder head is not removed, the cylinder head is installed on the pipe bender equipment, which can easily cause the equipment to be blocked or a certain work to be stuck. Long-term reciprocation of the drive iron pin by the hydraulic cylinder in the hydraulic cylinder can easily cause scratches on the inside of the steel drum, thereby causing the oil in the piston rod to lose working pressure.

The same is true when installing hydraulic valves. Clean the oil gallery plate and install it in a clean environment.

Lifting of hydraulic pipe bender

1. The center of gravity of the hydraulic pipe bender is relatively high, and the front is heavy and the back is light. Therefore, pay attention to the center of gravity during the whole process of hoisting, transportation and installation to prevent overturning accidents. When raising, the intersection angle of the raising wire should be as small as possible to ensure that the precision of the CNC lathe will not change.

2. The upper and lower poles of the hydraulic pipe bending equipment are located at the top of the operating table. As a standard for accurate measurement, the vertical and horizontal directions should be less than or equal to 1000:0.2. Prepare in advance according to the basic drawing, install hydraulic pipe bending equipment, install anchor screws and grouting. After the concrete is completely set, tighten the anchor bolts and check the level.